![free download slicer program for 3d printer and blockscad free download slicer program for 3d printer and blockscad](https://www.howlifeusa.com/wp-content/uploads/2022/01/windows3d3d-builder.png)
This does not affect the colour of your pendant, as that depends on the colour of the filament that you use. If you like, you can click on the coloured square to change the colour used in the viewer.
![free download slicer program for 3d printer and blockscad free download slicer program for 3d printer and blockscad](https://i.all3dp.com/cdn-cgi/image/fit=cover,w=360,gravity=0.5x0.5,format=auto/wp-content/uploads/2016/12/27040218/3DPrinterOS.png)
This will remove a smaller cylinder from the centre. Add another cylinder block in the bottom space, and this time give it a radius of 11 mm.
![free download slicer program for 3d printer and blockscad free download slicer program for 3d printer and blockscad](https://www.3dsourced.com/wp-content/uploads/2020/03/Free-3D-modeling-software-for-beginners.jpg)
Now, drag a difference block from Set Ops to encase the cylinder.
FREE DOWNLOAD SLICER PROGRAM FOR 3D PRINTER AND BLOCKSCAD CODE
(This means that the Z-axis value is greater than 0.)Ĭlick on the Render button after each change to your code to see the results. Select not centered so that the pendant sits on the surface. Cylinders are automatically centred along the X and Y axes. Create a cylinder with a radius of 12, and a height of 2 (the unit here is millimetres). As mentioned, the pendant is 40 mm wide, plus the hoop for hanging, which is 2 mm thick.Ĭlick 3D Shapes and drag a cylinder block to the project. The design uses six interlocking hoops in the centre, and a larger hoop around the outside. Open Chromium and enter the BlocksCAD editor URL: /editor. This project can be completed in a web browser using BlocksCAD. It is 2 mm thick, so it will 3D-print quite quickly.Īfter this project, you’ll also be able to code your own design and create a custom pendant. The pendant has a diameter of 40 mm, plus the hoop for hanging. There’s a hoop on top of the pendant so that you can put it on a necklace or cord. The pendant is small and only uses a little bit of filament. If you have access to a 3D printer, then you can print your pendant. The finished pendant with a cord threaded through the small hanging hoop